|
To apply grout to
ceramic tile it is important that you use the right materials and tools. First,
it is always best to check with the ceramic tile manufacturer to confirm the
appropriate grout mix to use with the particular ceramic tiles you are using for
your project.
Grout Materials
Required
-
Water
-
Grout mix
-
Grout sealer
Tools
|
|
Safety first
Make sure you wear
safety glasses when applying grout. Also, use a mask when mixing the grout as it
is very dusty. Finally, knee pads help to make the job less painful.
Mixing Grout
Since grout plays
both an aesthetic and functional role, it is important that the grout is applied
properly. If the grout is not applied correctly, the grout could separate from
the ceramic tiles over time leading to frequent repair and maintenance. Also, if
the grout is not applied properly your ceramic tile project could become
susceptible to water damage. |
To begin the
application of grout, first mix up the grout mix with the appropriate amount of
water as per the grout instructions. It is best to pour the water into the
bucket first and then slowly add in the grout mixture. Use the drill and mixing
bit while pouring in the grout mixture.
Once the grout
mixture is loose enough to flow, but not runny, it is of the correct
consistency.
Applying Grout
to Ceramic Tile
To begin applying
the grout, first remove any spacers that you may have placed between the ceramic
tiles when installing them.
Next make sure the
ceramic tile area is clean from dust. You may want to run a vacuum hose over the
ceramic tile area, focusing carefully on the seams where the grout will be
applied.
Starting in one
corner of the ceramic tile area apply the grout to the ceramic tile using a
rubber grout float. Work the grout float at a 45 degree angle over the seams.
Make sure the grout is tightly worked into the seams.
|
Find a Qualified Ceramic Tile Contractor in Your Area |
|
Get Free Quotes. Easy, Quick and No
Obligations!
For the home improvement or home remodeling project that is
too big for you, check out our partner
NeedContractor. They are a national
resource for finding pre-screened, insured, and licensed home improvement and remodeling contractors in your local area.
|
|
|
Get Matched in 48 hours with Ceramic Tile
Contractors! |
Allow the grout to
sit a few minutes and then using a sponge wipe the surface area of the ceramic
tile to remove the dry film / haze. Remember to frequently rinse the sponge in
the bucket of clean water. Also, when using the sponge, go carefully near the
grout lines so that you do not inadvertently remove the grout from the ceramic
tile seams.
If the ceramic tile
area is a large area, you may need to apply grout in sections, as you do not
want to allow the grout to set too long before wiping down the ceramic tiles.
After you have
applied grout to the entire ceramic tile area, get a fresh bucket of water and
again wipe down all of the ceramic tiles. You may need to repeat this process 2
or 3 times to totally eliminate the dry film / haze.
Allow the grout to
cure per the grout manufacturers instructions and then apply a grout sealer.
For information on
ceramic tile and installing a shower pan membrane liner, see the
Shower
Pan Membrane Liner Installation Ebook
from HomeAdditionPlus.com. The Shower Pan Membrane Liner EBook will quickly
teach you the step-by-step process for installing the shower pan membrane liner
correctly. It includes instructions on framing the shower stall, pouring the
pre-slope and shower base mortar, and installing the shower pan membrane liner.
See HomeAdditionPlus.com's
Ceramic Tile Calculator
How to Finance your
New Home Project - FirstAgain can
help provide funds for your new home improvement project if financing is
required.
Apply online today !
Related Ceramic Tile
Information
Additional Ceramic Tile Resources from Amazon.com
|
